<- RFC Index (1401..1500)
RFC 1428
Network Working Group G. Vaudreuil
Request for Comments: 1428 CNRI
February 1993
Transition of Internet Mail from
Just-Send-8
to 8bit-SMTP/MIME
Status of this Memo
This RFC provides information for the Internet community. It does
not specify an Internet standard. Distribution of this memo is
unlimited.
Abstract
Protocols for extending SMTP to pass 8bit characters have been
defined [3] [4]. These protocols require that messages transported by
the extended SMTP are to be encoded in MIME [1] [2]. Before work
began on these protocols, several SMTP implementations adopted ad-hoc
mechanisms for sending 8bit data. It is desirable for the extended
SMTP environment and these ad hoc mechanisms interoperate. This
document outlines the problems in this environment and an approach to
minimizing the cost of transition from current usage of non-MIME 8bit
messages to MIME.
1. Terminology
RFC 821 defines a 7bit transport. A transport agent which does not
clear the high order bit upon receipt of octets with this bit set in
SMTP messages is called 8 bit transparent in this document. An
implementation of the general SMTP Extensions document [3] and the
8bit extensions protocol [4] which passes MIME messages using all 8
bits of an octet is called 8bit ESMTP. An implementation of extended
SMTP which does not accept 8bit characters is called 7bit ESMTP. A
gateway is defined to be a transport agent with User Agent authority
to alter or convert the content of a message.
2. The Problem
SMTP as defined in RFC 821 limits the sending of Internet Mail to
US-ASCII [5] characters. As the Internet has grown to include non-
English correspondents, the need to communicate with character sets
other than US-ASCII has prompted many vendors and users to extend
SMTP or RFC 822 to use non-ASCII character sets. Common approaches
are to send 7 bit national variant ISO 646 character sets over
current RFC822/SMTP, to extend SMTP and RFC822 to use 8bit ISO 8859
Vaudreuil [Page 1]
RFC 1428 Transition to 8bit-SMTP/MIME February 1993
character sets, and to use proprietary PC character sets.
A third approach is used for Japanese mail. Japanese characters are
represented by pairs of octets with the high order bit cleared.
Switching between 14 bit character sets and 7 bit character sets is
indicated within the message by ISO 2022 escape sequences.
So long as these implementations can communicate without intermediate
transformations and have a loose private agreement on the use of a
specific character set without tagging, basic mail service can be
provided.
In the transition to the negotiated 8bit ESMTP/MIME environment, it
is important that mail sent by a currently non-conforming user can be
read by another non-conforming user. This existing functionality is
reduced by conversion from 8bit text to text encoded in unreadable
Base-64 or "garbled" text encoded in quoted printable.
There are several interesting non-interoperable cases that currently
exist in non US-ASCII mail and several new ones likely to emerge in a
transition to 8bit/MIME. Below is a listing of the transition-to-
mime cases. Only solutions to (4) in the context of a translating
gateway are discussed in this memo.
\ Receiver
\ 7bit 8bit MIME/
Sender \| only | transparent | ESMTP
----------------------------------------
7bit only | (1) | (1) | (1)
----------------------------------------
8bit transparent | (2) | (3) | (4)
----------------------------------------
MIME/ESMTP | (5) | (5) | (6)
(1) 7Bit non-MIME sender to 7bit, MIME, or 8bit transparent receiver
This will continue to work unchanged with nationally varient ISO
646 or ISO 2022 character set shifting if an external "out of
band" agreement exists between the sender and the receiver. A
7bit to 8bit/ESMTP gateway need not alter the content of this
message.
(2) 8bit sender to 7bit non-MIME receiver
The receiver will receive bit-stripped mail which results in the
mis-interpretation of the data and the wrong character being
displayed or printed. Mail sent using languages where most
Vaudreuil [Page 2]
RFC 1428 Transition to 8bit-SMTP/MIME February 1993
characters are in the US-ASCII subset of ISO 8859 may be somewhat
readable.
(3) 8bit transparent sender to 8bit transparent receiver
Will work if an external agreement "out of band" to use a
particular character set without tagging exists between the sender
and the receiver.
(4) 8bit transparent sender to MIME/ESMTP conformant receiver
Will work if a reasonable upgrade path is provided via gateways,
the indicated character set tag inserted by the gateway is correct
and the receiver supports the character set chosen by the sender.
This case is the focus of this memo.
(5) MIME/ESMTP sender to non-MIME 7bit receiver
Because the ESMTP/MIME sender cannot know if the receiver will
understand 8bits, the sender will encode the text into base-64 or
quoted-printable which may be considered "garbled" by the
receiver. To provide a useful downgrade path the gateway must
have some knowledge about the capabilities of the receiver. When
the character set can be clearly identified, techniques like the
menmonic MNEM encoding described in RFC 1345 may be helpful in
this case.
(6) MIME/ESMTP sender to MIME/ESMTP receiver
Interoperability will be attained provided the receiver supports
the character set chosen by the sender.
3. Upgrade Path from 8bit Transparent to ESMTP/MIME
A gateway which has been upgraded to support Extended SMTP may
upgrade an 8bit message received to MIME. This is consistent with
the requirement that all 8bit mail sent by ESMTP be encoded in MIME.
The upgrade should be done using the best available information.
A site may "upgrade" to MIME en-masse by implementing MIME conversion
for all messages leaving the site. For text messages, the body can
be converted by adding a MIME-version header and a Content-Type:
Text/Plain with the character set in use in the site, provided the
site uses a single character set.
An appropriate Content-Transfer-Encoding header line must be added to
indicate any encoding that may be necessary.
Vaudreuil [Page 3]
RFC 1428 Transition to 8bit-SMTP/MIME February 1993
Example:
MIME-Version: 1.0
Content-Type: Text/Plain; Charset = ISO-8859-1
Content-Transfer-Encoding: 8bit
If no information about the character set in use is available, the
gateway should upgrade the content by using the character set
"unknown-8bit". The unknown-8bit value of the charset parameter
indicates only that no reliable information about the character
set(s) used in the message was available.
If a message body has been upgraded to MIME, the RFC 822 headers
containing non US-ASCII characters must be upgraded to conform with
the header encoding rules of RFC1342. A gateway should recode all
unstructered header fields as well as RFC 822 "comment"s and
"phrase"s according to the rules of RFC 1342. There is no equivalent
in RFC 1342 to the "8bit" Content-Transfer-Encoding value for message
bodies so all 8bit header text must be transformed according to
either the "B" or the "Q" encoding method. For ISO 8859 character
sets, the "Q" encoding will generally result in somewhat readable
headers.
Trace information should be added to the document with a convert
clause: "rfc822-to-8bit", "rfc822-to-base-64" or "rfc822-to-quoted-
printable" e.g.,
Received: from dbc.mtview.ca.us by dbc.mtview.ca.us
convert rfc822-to-8bit; Tue, 01 Sep 1992 01:18:00 -0700
Appendix - The "unknown-8bit" Character Set
This section defines a "charset" parameter, for use in a MIME
Content-Type field.
A special purpose character set called "unknown-8bit" is defined to
be an unknown 8bit character set, encoded into a sequence of octets.
It can be used as a label for any character set from any language,
using any encoding. It must not be further defined.
The use of this token in a "charset=" field of a message indicates
that nothing is known about the character set used. This marker is
intended for use by non-MIME to MIME gateways; specifically in those
which translate from SMTP to 8bit ESMTP/MIME.
This character set is not intended to be used by mail composers. It
is assumed that the mail composer knows the character set in use and
will mark it with a character set value as specified in [1], as
Vaudreuil [Page 4]
RFC 1428 Transition to 8bit-SMTP/MIME February 1993
amended by current Assigned Numbers documents [6].
The use of the "unknown-8bit" label is intended only by mail gateway
agents which cannot determine via out-of-band information the
intended character set.
The interpretation of the "unknown-8bit" is up to the mail reader.
It is assumed that in many cases the human user will be able to
interpret the information and choose an appropriate character set or
pre-processor.
Acknowledgements
This document originated as a hallway conversation between Ned Freed,
Neil Katin, and the author. Substantive input was received from
Jonathan Laventhol, Craig Everhart, Olle Jarnefors, and Olafur
Gudmundsson. The document was refined with the input of many
participants in the IETF SMTP Extensions Working Group.
References
[1] Borenstein, N., and N. Freed, "Multipurpose Internet Mail
Extensions", RFC 1341, Bellcore, Innosoft, June 1992.
[2] Moore, K., "Representation of Non-ASCII Text in Internet Message
Headers", RFC 1342, University of Tennessee, June 1992.
[3] Klensin, J., WG Chair, Freed, N., Editor, Rose, M., Stefferud,
E., and D. Crocker, "SMTP Service Extensions" RFC 1425, United
Nations University, Innosoft International, Inc., Dover Beach
Consulting, Inc., Network Management Associates, Inc., The Branch
Office, February 1993.
[4] Klensin, J., WG Chair, Freed, N., Editor, Rose, M., Stefferud,
E., and D. Crocker, "SMTP Service Extensions for 8bit
MIMEtransport", RFC 1426, United Nations University, Innosoft
International, Inc., Dover Beach Consulting, Inc., Network
Management Associates, Inc., The Branch Office, February 1993.
[5] Coded Character Set--7-Bit American Standard Code for Information
Interchange, ANSI X3.4-1986.
[6] Reynolds, J., and J. Postel, "Assigned Numbers", STD 2, RFC 1340,
USC/Information Sciences Institute, July 1992.
Security Considerations
Security issues are not discussed in this memo.
Vaudreuil [Page 5]
RFC 1428 Transition to 8bit-SMTP/MIME February 1993
Author's Address
Greg Vaudreuil
Corporation for National Research Initiatives
1895 Preston White Drive, Suite 100
Reston, VA 22091 USA
Phone: (703) 620-8990
EMail: GVaudre@CNRI.Reston.VA.US
Vaudreuil [Page 6]