<- RFC Index (2401..2500)
(also RFC 1201)
Updated by RFC 8064
Network Working Group I. Souvatzis
Request for Comments: 2497 The NetBSD Project
See Also: 1201 January 1999
Category: Standards Track
Transmission of IPv6 Packets over ARCnet Networks
Status of this Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (1999). All Rights Reserved.
1. Introduction
This memo specifies a frame format for transmission of IPv6 [IPV6]
packets and the method of forming IPv6 link-local and statelessly
autoconfigured addresses on ARCnet networks. It also specifies the
content of the Source/Target Link-layer Address option used by the
Router Solicitation, Router Advertisement, Neighbor Solicitation,
Neighbor Advertisement and Redirect messages described in [DISC],
when those messages are transmitted on an ARCnet.
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL
NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL"
in this document are to be interpreted as described in RFC 2119
[KWORD].
2. Frame Format
IPv6 packets are link layer fragmented and reassembled according to
[PHDS]. A brief but sufficient discussion of this fragmentation
method can be found in [ARCIPV4].
The protocol ID (System Code in ARCnet terminology) assigned to IPv6
is C4 hexadecimal.
Souvatzis Standards Track [Page 1]
RFC 2497 IPv6 Datagrams on ARCnet January 1999 3. Maximum Transmission Unit The maximum IPv6 packet length possible using this encapsulation method is 60480 octets. Since this length is impractical because of its worst case transmission time of several seconds, all ARCnet implementations on a given ARCnet network should agree on a smaller value. The default MTU for IPv6 [IPV6] packets on an ARCnet is 9072 octets. In the presence of a router, this size MAY be changed by a Router Advertisement [DISC] containing an MTU option. If a Router Advertisement is received with an MTU option specifying an MTU larger than 60480, or larger than a manually configured value less than 60480, that MTU option may be logged to system management but MUST be otherwise ignored. If no router is available, the local MTU MUST be left at 9072 or MUST be manually configured to the same different value on all connected stations. Implementations MAY accept arriving IPv6 datagrams which are larger than their configured maximum transmission unit. They are not required to discard such datagrams. If they can not handle larger datagrams, they MAY log the event to the system administration, but MUST otherwise silently discard them. 4. Stateless Auto-configuration If a node has an EUI-64 which is not used to form the Interface Identifier for any other interface, it SHOULD use that EUI-64 to form the Interface Identifier for its ARCnet interface. If that EUI-64 is in use for another interface attached to a different link, it MAY be used for the ARCnet interface as well. The Interface Identifier is then formed from the EUI-64 by complementing the "Universal/Local" (U/L) bit, which is the next- to-lowest order bit of the first octet of the EUI-64. When a node has no EUI-64 available for forming its ARCnet Interface Identifer, it MUST form that identifier as specified in [AARCH], Appendix A, section "Links with Non-Global Identifier". That is, the 8 bit manually configured ARCnet address is appended to the 56 zero bits. For example, for an ARCnet interface with the configured address of 49 hexadecimal this results in the following identifier: Souvatzis Standards Track [Page 2]
RFC 2497 IPv6 Datagrams on ARCnet January 1999
|0 1|1 3|3 4|4 6|
|0 5|6 1|2 7|8 3|
+----------------+----------------+----------------+----------------+
|0000000000000000|0000000000000000|0000000000000000|0000000001001001|
+----------------+----------------+----------------+----------------+
Note that this results in the universal/local bit set to "0" to
indicate local scope.
An IPv6 address prefix used for stateless auto-configuration [ACONF]
of an ARCnet interface MUST have a length of 64 bits.
5. Link-Local Addresses
The IPv6 link-local address [AARCH] for an ARCnet interface is formed
by appending the Interface Identifier, as defined above, to the
prefix FE80::/64.
10 bits 54 bits 64 bits
+----------+-----------------------+----------------------------+
|1111111010| (zeros) | Interface Identifier |
+----------+-----------------------+----------------------------+
6. Address Mapping -- Unicast
The procedure for mapping IPv6 addresses into ARCnet link-layer
addresses is described in [DISC]. The Source/Target link layer
Address option has the following form when the link layer is ARCnet.
0 1
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type | Length |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
|ARCnet address | |
+---------------+ -+
| |
+- 5 octets of padding -+
| |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Option fields:
Type 1 for Source Link-layer address.
2 for Target Link-layer address.
Length 1 (in units of 8 octets).
ARCnet address The 8 bit ARCnet address, in canonical bit order.
Souvatzis Standards Track [Page 3]
RFC 2497 IPv6 Datagrams on ARCnet January 1999
7. Address Mapping -- Multicast
As ARCnet only provides 1 multicast address (00 hexadecimal), all
IPv6 multicast addresses MUST be mapped to this address.
8. Security Considerations
The method of derivation of Interface Identifiers from ARCnet
addresses is intended to preserve local uniqueness when possible.
However, there is no protection from duplication through accident or
forgery.
9. Acknowledgements
Big parts of the new version of this memo are either based on
[ETHIPV6] or on Matt Crawford's review of an earlier version.
10. References
[AARCH] Hinden, R. and S. Deering, "IP Version 6 Addressing
Architecture", RFC 2373, July 1998.
[ACONF] Thomson, S. and T. Narten, "IPv6 Stateless Address
Autoconfiguration", RFC 2462, December 1998.
[ARCIPV4] Provan, D., "Transmitting IP Traffic over ARCNET Networks",
RFC1201, Novell, Inc., February 1991.
[DISC] Narten, T., Nordmark, E. and W. Simpson, "Neighbor
Discovery for IP Version 6 (IPv6)", RFC 2461, December
1998.
[ETHIPV6] Crawford, M., "Transmission of IPv6 Packets over Ethernet
Networks", RFC 2464, December 1998.
[EUI64] "64-Bit Global Identifier Format Tutorial", http://stan
dards.ieee.org/db/oui/tutorials/EUI64.html.
[IPV6] Deering, S. and R. Hinden, "Internet Protocol, Version 6
(IPv6) Specification", RFC 2460, December 1998.
[KWORD] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[PHDS] Novell, Inc., "ARCNET Packet Header Definition Standard",
Novell Part Number 100-00721-001, November 1989.
Souvatzis Standards Track [Page 4]
RFC 2497 IPv6 Datagrams on ARCnet January 1999 11. Author's Address Ignatios Souvatzis The NetBSD Project Stationenweg 29 D-53332 Bornheim Germany Phone (work): +49 (228) 734316 EMail: is@netbsd.org Souvatzis Standards Track [Page 5]
RFC 2497 IPv6 Datagrams on ARCnet January 1999 12. Full Copyright Statement Copyright (C) The Internet Society (1999). All Rights Reserved. This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English. The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns. This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Souvatzis Standards Track [Page 6]