<- RFC Index (4301..4400)
RFC 4311
Updates RFC 2461
Network Working Group R. Hinden
Request for Comments: 4311 Nokia
Updates: 2461 D. Thaler
Category: Standards Track Microsoft
November 2005
IPv6 Host-to-Router Load Sharing
Status of This Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2005).
Abstract
The original IPv6 conceptual sending algorithm does not do load
sharing among equivalent IPv6 routers, and suggests schemes that can
be problematic in practice. This document updates the conceptual
sending algorithm in RFC 2461 so that traffic to different
destinations can be distributed among routers in an efficient
fashion.
1. Introduction
In the conceptual sending algorithm in [ND] and in the optional
extension in [ROUTERSEL], a next hop is chosen when no destination
cache entry exists for an off-link destination or when communication
through an existing router is failing. Normally, a router is
selected the first time traffic is sent to a specific destination IP
address. Subsequent traffic to the same destination address
continues to use the same router unless there is some reason to
change to a different router (e.g., a redirect message is received,
or the router is found to be unreachable).
In addition, as described in [ADDRSEL], the choice of next hop may
also affect the choice of source address, and hence indirectly (and
to a lesser extent) may affect the router used for inbound traffic as
well.
Hinden & Thaler Standards Track [Page 1]
RFC 4311 IPv6 Host-to-Router Load Sharing November 2005
In both the base sending algorithm and in the optional extension,
sometimes a host has a choice of multiple equivalent routers for a
destination. That is, all other factors are equal and a host must
break a tie via some implementation-specific means.
It is often desirable when there is more than one equivalent router
that hosts distribute their outgoing traffic among these routers.
This shares the load among multiple routers and provides better
performance for the host's traffic.
On the other hand, load sharing can be undesirable in situations
where sufficient capacity is available through a single router and
the traffic patterns could be more predictable by using a single
router; in particular, this helps to diagnose connectivity problems
beyond the first-hop routers.
[ND] does not require any particular behavior in this respect. It
specifies that an implementation may always choose the same router
(e.g., the first in the list) or may cycle through the routers in a
round-robin manner. Both of these suggestions are problematic.
Clearly, always choosing the same router does not provide load
sharing. Some problems with load sharing using naive tie-breaking
techniques such as round-robin and random are discussed in
[MULTIPATH]. While the destination cache provides some stability
since the determination is not per packet, cache evictions or
timeouts can still result in unstable or unpredictable paths over
time, lowering the performance and making it harder to diagnose
problems. Round-robin selection may also result in synchronization
issues among hosts, where in the worst case the load is concentrated
on one router at a time.
In the remainder of this document, the key words "MUST", "MUST NOT",
"REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT",
"RECOMMENDED", "MAY", and "OPTIONAL" are to be interpreted as
described in [RFC2119].
2. Load Sharing
When a host chooses from multiple equivalent routers, it SHOULD
support choosing using some method that distributes load for
different destinations among the equivalent routers rather than
always choosing the same router (e.g., the first in the list). This
memo takes no stance on whether the support for load sharing should
be turned on or off by default. Furthermore, a host that does
attempt to distribute load among routers SHOULD use a hash-based
scheme that takes (at least) the destination IP address into account,
such as those described in [MULTIPATH], for choosing a router to use.
Hinden & Thaler Standards Track [Page 2]
RFC 4311 IPv6 Host-to-Router Load Sharing November 2005
Note that traffic for a given destination address will use the same
router as long as the Destination Cache Entry for the destination
address is not deleted. With a hash-based scheme, traffic for a
given destination address will use the same router over time even if
the Destination Cache Entry is deleted, as long as the list of
equivalent routers remains the same.
3. Security Considerations
As mentioned in [MULTIPATH], when next-hop selection is predictable,
an application can synthesize traffic that will all hash the same,
making it possible to launch a denial-of-service attack against the
load-sharing algorithm, and overload a particular router. This can
even be done by a remote application that can cause a host to respond
to a given destination address. A special case of this is when the
same (single) next-hop is always selected, such as in the algorithm
allowed by [ND]. Introducing hashing can make such an attack more
difficult; the more unpredictable the hash is, the harder it becomes
to conduct a denial-of-service attack against any single router.
However, a malicious local application can bypass the algorithm for
its own traffic by using mechanisms such as raw sockets, and remote
attackers can still overload the routers directly. Hence, the
mechanisms discussed herein have no significant incremental impact on
Internet infrastructure security.
4. Acknowledgements
The authors of this document would like to thank Erik Nordmark, Brian
Haberman, Steve Deering, Aron Silverton, Christian Huitema, and Pekka
Savola.
Hinden & Thaler Standards Track [Page 3]
RFC 4311 IPv6 Host-to-Router Load Sharing November 2005
5. Normative References
[ND] Narten, T., Nordmark, E., and W. Simpson, "Neighbor
Discovery for IP Version 6 (IPv6)", RFC 2461, December
1998.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[ADDRSEL] Draves, R., "Default Address Selection for Internet
Protocol version 6 (IPv6)", RFC 3484, February 2003.
[ROUTERSEL] Draves, R. and D. Thaler, "Default Router Preferences
and More-Specific Routes", RFC 4191, November 2005.
6. Informative References
[MULTIPATH] Thaler, D. and C. Hopps, "Multipath Issues in Unicast
and Multicast Next-Hop Selection", RFC 2991, November
2000.
Authors' Addresses
Robert Hinden
Nokia
313 Fairchild Drive
Mountain View, CA 94043
Phone: +1 650 625-2004
EMail: bob.hinden@nokia.com
Dave Thaler
Microsoft Corporation
One Microsoft Way
Redmond, WA 98052
Phone: +1 425 703 8835
EMail: dthaler@microsoft.com
Hinden & Thaler Standards Track [Page 4]
RFC 4311 IPv6 Host-to-Router Load Sharing November 2005
Full Copyright Statement
Copyright (C) The Internet Society (2005).
This document is subject to the rights, licenses and restrictions
contained in BCP 78, and except as set forth therein, the authors
retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at ietf-
ipr@ietf.org.
Acknowledgement
Funding for the RFC Editor function is currently provided by the
Internet Society.
Hinden & Thaler Standards Track [Page 5]