<- RFC Index (5001..5100)
RFC 5029
Updated by RFC 9650
Network Working Group JP. Vasseur
Request for Comments: 5029 S. Previdi
Category: Standards Track Cisco Systems, Inc
September 2007
Definition of an IS-IS Link Attribute Sub-TLV
Status of This Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Abstract
This document defines a sub-TLV called "Link-attributes" carried
within the TLV 22 and used to flood some link characteristics.
Table of Contents
1. Introduction ....................................................2
1.1. Terminology ................................................2
2. Link-Attributes Sub-TLV Format ..................................2
3. Interoperability with Routers Not Supporting This Capability ....3
4. IANA Considerations .............................................3
5. Security Considerations .........................................3
6. Acknowledgements ................................................3
7. References ......................................................4
7.1. Normative References .......................................4
7.2. Informative References .....................................4
Vasseur & Previdi Standards Track [Page 1]
RFC 5029 IS-IS Link Attribute September 2007
1. Introduction
[IS-IS] specifies the IS-IS protocol (ISO 10589) with extensions to
support IPv4 in [RFC1195]. A router advertises one or several Link
State Protocol data units that are composed of variable length tuples
called TLVs (Type-Length-Value).
[RFC3784] defines a set of new TLVs whose aims are to add more
information about links characteristics, increase the range of IS-IS
metrics, and optimize the encoding of IS-IS prefixes.
This document defines a new sub-TLV named "Link-attributes" carried
within the extended IS reachability TLV (type 22) specified in
[RFC3784].
1.1 Terminology
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in RFC 2119 [RFC2119].
2. Link-Attributes Sub-TLV Format
The link-attribute sub-TLV is carried within the TLV 22 and has a
format identical to the sub-TLV format used by the Traffic
Engineering Extensions for IS-IS ([RFC3784]): 1 octet of sub-type, 1
octet of length of the value field of the sub-TLV followed by the
value field -- in this case, a 16 bit flags field.
The Link-attribute sub-type is 19 and the link-attribute has a length
of 2 octets.
This sub-TLV is OPTIONAL and MUST appear at most once for a single IS
neighbor. If a received Link State Packet (LSP) contains more than
one Link-Attribute Sub-TLV, an implementation SHOULD decide to
consider only the first encountered instance.
The following bits are defined:
Local Protection Available (0x01). When set, this indicates that the
link is protected by means of some local protection mechanism (e.g.,
[RFC4090]).
Link excluded from local protection path (0x02). When set, this link
SHOULD not be included in any computation of a repair path by any
other router in the routing area. The triggers for setting up this
bit are out of the scope of this document.
Vasseur & Previdi Standards Track [Page 2]
RFC 5029 IS-IS Link Attribute September 2007
3. Interoperability with Routers Not Supporting This Capability
A router not supporting the link-attribute sub-TLV will just silently
ignore this sub-TLV.
4. IANA Considerations
IANA has assigned codepoint 19 for the link-attribute sub-TLV defined
in this document and carried within TLV 22.
IANA has created a registry for bit values inside the link-attributes
sub-TLV. The initial contents of this registry are as follows
Value Name Reference
----- ---- ---------
0x1 Local Protection Available [RFC5029]
0x2 Link Excluded from Local Protection [RFC5029]
Further values are to be allocated by the Standards Action process
defined in [RFC2434], with Early Allocation (defined in [RFC4020])
permitted.
5. Security Considerations
Any new security issues raised by the procedures in this document
depend upon the opportunity for LSPs to be snooped and modified, the
ease/difficulty of which has not been altered. As the LSPs may now
contain additional information regarding router capabilities, this
new information would also become available to an attacker.
Specifications based on this mechanism need to describe the security
considerations around the disclosure and modification of their
information. Note that an integrity mechanism, such as one defined
in [RFC3567], should be applied if there is high risk resulting from
the modification of capability information.
6. Acknowledgements
The authors would like to thank Mike Shand, Les Ginsberg, and Bill
Fenner for their useful comments.
Vasseur & Previdi Standards Track [Page 3]
RFC 5029 IS-IS Link Attribute September 2007
7. References
7.1. Normative References
[IS-IS] "Intermediate System to Intermediate System Intra-Domain
Routing Exchange Protocol for use in Conjunction with the
Protocol for Providing the Connectionless-mode Network
Service (ISO 8473)", ISO 10589.
[RFC1195] Callon, R., "Use of OSI IS-IS for routing in TCP/IP and
dual environments", RFC 1195, December 1990.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[RFC2434] Narten, T. and H. Alvestrand, "Guidelines for Writing an
IANA Considerations Section in RFCs", BCP 26, RFC 2434,
October 1998.
[RFC3784] Smit, H. and T. Li, "Intermediate System to Intermediate
System (IS-IS) Extensions for Traffic Engineering (TE)",
RFC 3784, June 2004.
[RFC4020] Kompella, K. and A. Zinin, "Early IANA Allocation of
Standards Track Code Points", BCP 100, RFC 4020, February
2005.
7.2. Informative References
[RFC3567] Li, T. and R. Atkinson, "Intermediate System to
Intermediate System (IS-IS) Cryptographic Authentication",
RFC 3567, July 2003.
[RFC4090] Pan, P., Swallow, G., and A. Atlas, "Fast Reroute
Extensions to RSVP-TE for LSP Tunnels", RFC 4090, May
2005.
Vasseur & Previdi Standards Track [Page 4]
RFC 5029 IS-IS Link Attribute September 2007
Authors' Addresses
JP Vasseur
Cisco Systems, Inc
1414 Massachusetts Avenue
Boxborough, MA 01719
USA
EMail: jpv@cisco.com
Stefano Previdi
Cisco Systems, Inc
Via Del Serafico 200
Roma 00142
Italy
EMail: sprevidi@cisco.com
Vasseur & Previdi Standards Track [Page 5]
RFC 5029 IS-IS Link Attribute September 2007
Full Copyright Statement
Copyright (C) The IETF Trust (2007).
This document is subject to the rights, licenses and restrictions
contained in BCP 78, and except as set forth therein, the authors
retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY, THE IETF TRUST AND
THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF
THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at
ietf-ipr@ietf.org.
Vasseur & Previdi Standards Track [Page 6]