<- RFC Index (501..600)
RFC 596
Network Working Group E. Taft
Request for Comments: 596 PARC-MAXC
NIC: 15372 8 December 1973
Second Thoughts on Telnet Go-Ahead
INTRODUCTION
In this RFC we present objections to the requirement that hosts
implement the Telnet Go-Ahead (GA) command, as specified in the
Telnet Protocol Specification (NIC #15372). The thrust of these
objections is in three major directions:
1. The GA mechanism is esthetically unappealing, both to myself
and to many other people I have talked to. I shall attempt to
describe why this is so.
2. As specified in the Protocol, GA will not, in general, work;
i.e. it will not serve its intended purpose unless hosts make
various unwarranted assumptions about how other hosts operate.
3. GA is impossible for most hosts to implement correctly in all
cases. This is certainly true of the PDP-10 operating systems
with which I am familiar (10/50 and Tenex).
The purpose of this RFC is to advocate either complete removal of the
GA mechanism or relegating it to the status of a negotiated option
whose default state is that it be suppressed.
TERMINOLOGY
"Half-duplex" is a two-way communication discipline in which
transmission takes place in only one direction at a time and the
receiving party is constrained not to transmit until the transmitting
party has explicitly given up control of the communication path
("turned the line around").
This definition is distinct from a common (but incorrect) use of the
terms "half-duplex" and "full-duplex" to designate local and remote
character echoing.
"Reverse break" is a means by which a computer connected to a
terminal by a half-duplex path may regain control of the path for
further typeout after previously having relinquished it.
Taft [Page 1]
RFC 596 Second Thoughts on Telnet Go-Ahead December 1973
This is the complement of the "break" or "attention" mechanism,
implemented by all half-duplex terminals, by means of which the user
may gain control of the line while it is in use by the computer.
ESTHETIC OBJECTIONS TO GA
One assumption that permeates the Telnet Protocol specification (and
is explicitly stated on Page 7) is that the "normal" mode of
communication between computers and terminals is half-duplex, line-
at-a-time. While historically this is partially true, it is also
clear, both within the ARPA Network community and elsewhere, that the
trend is toward highly interactive man-machine communication systems
which are difficult to implement under half-duplex communication
disciplines.
The GA mechanism is an attempt to solve a specific problem, that of
switching control between computer and user in a subset of those
hosts utilizing IBM 2741 or equivalent terminals. I say "a subset"
because in fact the problem arises only in the case of TIPs from
2741s (with reverse break); from what experience I have had, I think
the TIP does a very good job of turning the line around at the right
moments. (I am told this is also the case at Multics).
Given the trend toward more interactive communication, and given the
fact that terminals on the Network requiring a Go-Ahead mechanism are
a distinct minority of all terminals, I think we should be reluctant
to burden our protocols with kludges that are so clearly a concession
to obsolete design.
I have little doubt that before long somebody (if not IBM) will
produce a full-duplex 2741-like terminal (indeed, perhaps it has
already been done). There is an obvious need for a terminal with
Selectric quality keyboard and hard-copy better suited to
interactive applications (i.e. full-duplex).
As a more practical consideration, it makes little sense to have the
default state of the GA option be the one that benefits the least
number of hosts and terminals.
There is no question that most parties to Telnet communication
will immediately negotiate to suppress GA. To do otherwise will
double the amount of network traffic generated by character-at-a-
time typein, and will increase it by a non-negligible amount even
for a line-at-a-time typein.
It strikes me as worthwhile to minimize the number of such
"necessary" option negotiations, especially in view of the large
number of TIPs and mini-hosts on the Network. Many such hosts
Taft [Page 2]
RFC 596 Second Thoughts on Telnet Go-Ahead December 1973
must, due to resource constraints, implement only a limited subset
of the available options. It follows, then, that the default
state of all options should be the one most hosts will be willing
to use.
WHY GA WON'T WORK
We now show that a server process's being "blocked on input" (as
specified in the Protocol) is not itself a sufficient condition for
sending out GA.
This is due to the fact that the user Telnet has no control over the
packaging of a "line" of information sent to the server; rather, this
is a function of the NCP, which must observe constraints such as
allocation and buffering. Consider the following example:
A user types a line of text, which is buffered by his host's user
Telnet until he signals end-of-line. His keyboard then becomes
locked (this being the behavior of half-duplex terminals while the
computer has control of the line), and stays locked in
anticipation of the server's eventual response and subsequent GA
command.
The user Telnet transmits this text line over the connection;
however, due to insufficient allocation or other conditions, the
text actually gets packaged up and sent as two or more separate
messages, which arrive at the server host in the correct order but
separated by some amount of time.
The server Telnet passes the contents of the first message to the
appropriate process, which reads the partial text line and
immediately blocks for further input. At this moment (assuming
the second message hasn't arrived yet), the server telnet, in
accordance with the Protocol, sends back a GA command.
The rest of the text then arrives in response, the server process
may generate a large volume of output. Meanwhile, however, the GA
command has caused the user's keyboard to become unlocked and
computer output thereby blocked. Hence we have a deadlock, which
will be resolved only when the user recognizes what has happened
and (manually) gives control back to the computer.
Of course, this particular problem is avoided if the Telnet protocol
is modified to specify that the server Telnet will transmit GA only
if the server process is blocked for input AND the most recent
character passed to that process was end-of-line.
Taft [Page 3]
RFC 596 Second Thoughts on Telnet Go-Ahead December 1973
I claim that this solution is bad in principle because it assumes
too much knowledge on the part of the serving host as to what
constitutes "end-of-line" in the using host.
Furthermore, the Protocol explicitly (and quite rightly) specifies
that the user Telnet should provide some means by which a user may
signal that all buffered text should be transmitted immediately,
without its being terminated by end-of-line.
One must conclude, then, that in general the server Telnet has no
precise way of knowing when it should send GA commands.
IMPLEMENTATION PROBLEMS
The foregoing analysis illustrates the problems that arise with the
GA mechanism in communication between servers and users whose normal
mode of operation is half-duplex, line-at-a-time. When we turn to
hosts that provide full-duplex service, such as the PDP-10s and many
other hosts on the Network, the problems are much more severe.
This is particularly true of operating system such as Tenex that
exercise such tight control over terminal behavior that they
prefer to operate in server echoing, character-at-a-time mode.
This will probably become less necessary as protocols such as
Remote Controlled transmission and Echoing Option come into
general use, enabling servers to regulate echoing and break
character classes in user Telnets.
Even in hosts such as 10/50 systems that provide reasonable service
to line-at-a-time users for most subsystems (e.g. excluding DDT and
TECO), GA is impossible to implement correctly. This is true for
several reasons.
First, there are a number of subsystems that never block for terminal
input but rather poll for it or accept it on an interrupt basis. In
the absence of typein, such processes go on to do other tasks,
possibly generating terminal output.
Processes of this sort come immediately to mind. The user telnet,
FTP, and RJE programs are implemented in this fashion by almost
all hosts. 10/50 has a subsystem called OPSER, used to control
multiple independent subjobs from a single terminal.
Since these programs never block for input, GA commands will never
be sent by the server Telnet in such cases even though the
processes are prepared to accept terminal input at any time.
Taft [Page 4]
RFC 596 Second Thoughts on Telnet Go-Ahead December 1973
Second, there is not necessarily a one-to-one relationship between
processes and terminals, as seems to be assumed by the Telnet
Protocol specification.
For example, in Tenex one process may be blocked for terminal
input while another process is generating output to the same
terminal. (Such processes are typically parallel forks of the
same job).
Third, there is the possibility of inter-terminal links, such as are
provided in many systems.
By this I do not mean special Telnet connections established
between a pair of NVTs for the express purpose of terminal-to-
terminal communication, as is suggested on page 9 of the Protocol
specification. Rather, I am referring to facilities such as the
Tenex LINK facility, in which any number and any mixture of local
and Network terminals and processes may have their input and
output streams linked together in arbitrarily complex ways.
Clearly the GA mechanism will fall flat on its face in this case.
Also, the notion that one user of an inter-terminal link should
have to "manually signal that it is time for a GA to be sent over
the Telnet connection" in order to unblock another user's keyboard
offends me to no end.
Finally, most systems provide means by which system personnel and
processes may broadcast important messages to all terminals (e.g.
SEND ALL in 10/50, NOTIFY in Tenex). Clearly such asynchronous
messages will be blocked by a half-duplex terminal that has been
irrevocably placed in the typein state by a previous GA.
This strikes me as such an obvious problem that I am forced to
wonder how half-duplex hosts handle it even for their local
terminals.
[ This RFC was put into machine readable form for entry ]
[ into the online RFC archives by Mirsad Todorovac 5/98 ]
Taft [Page 5]